ASTM A193 Grade B7 And B7M And B16 And B8 And B8M Threaded Rods

Selection will depend upon design, service conditions, mechanical properties, and high temperature characteristics.

ASTM A307 Grade A And B Threaded Rods

When tested, sampled specimens shall adhere to specified values for chemical composition, hardness, tensile strength, yield point, elongation, and dimensions.

ASTM A320 Grade L7 And L7M And L43 Threaded Rods

When tested, sampled specimens shall adhere to specified values for chemical composition, hardness, tensile strength, yield point, elongation, and dimensions.

DIN975 Class 4.8 And 6.8 And 8.8 And 10.9 And 12.9 Threaded Rods

Surface hardness shall not be more than 30 Vickers points above the measured core hardness of the fastener when determination of both surface hardness and core hardness are carried out with HV 0,3.

ANSI Grade 2 And 5 And 8 Threaded Rods

SAE J429 standard covers specifications to chemical, mechanical and other material requirements for inch-series carbon and alloy steel bolts, screws, studs, and U-bolts, used in automotive and related industries in sizes up-to 1-1/2 inch, inclusive.

ASTM A193 Grade B7 And B7M And B16 And B8 And B8M Stud Bolts

The ASTM A193 specification covers alloy-steel and stainless steel stud bolts materials for high temperature or high-pressure service.

ASTM A307 Grade A And B Stud Bolts

ASTM A307 specification covers the chemical and mechanical requirements for three grades (Grades A, B, and C) of carbon steel bolts, studs, threaded rods with minimum tensile requirement of 60 ksi. However Grade C has been replaced by ASTM F1554 Grade 36 Specification.

ASTM A320 Grade L7 And L7M And L43 Stud Bolts

ASTM A307 specification covers the chemical and mechanical requirements for three grades (Grades A, B, and C) of carbon steel bolts, studs, threaded rods with minimum tensile requirement of 60 ksi. However Grade C has been replaced by ASTM F1554 Grade 36 Specification.

DIN976 Class 4.8 And 6.8 And 8.8 And 10.9 And 12.9 Stud Bolts

This alloy steel shall contain at least one of the following elements in the minimum quantity given: chromium 0,30 %, nickel 0,30 %, molybdenum 0,20 %, vanadium 0,10 %.

ANSI Grade 2 And 5 And 8 Stud Bolts

SAE J429 standard covers specifications to chemical, mechanical and other material requirements for inch-series carbon and alloy steel bolts, screws, studs, and U-bolts, used in automotive and related industries in sizes up-to 1-1/2 inch, inclusive.